3tons Low Level Transmission Jack
First, the basic function
The hydraulic lift conveyor is the introduction of foreign
prototype, combined with the domestic automobile repair and
maintenance industry requirements and characteristics of careful
design.It is mainly used for the high installation and disassembly of
automobile gearbox, engine, transmission motor, front and rear axle
and other objects whose weight does not exceed 2T. It is an
indispensable lifting and transporting tool for automobile repair
and maintenance factory. It is the supporting equipment of column
or shear type automobile lifting equipment.
Two, use method
1, with the pillar or scissor lift to lift the car to a certain
height.
2, Push the hydraulic lift under the car, and lift the hydraulic
lift to the appropriate position, and remove the objects to be
repaired (such as:Gearbox, engine, drive shaft, front and rear axle, etc.) are placed
in the center of the bracket, and then the object is fastened with
steel chain, and the unloading valve is opened.Put what the bracket and objects.
3, Push the hydraulic lift to the desired position.Under the object with the crane maintenance.
4, After the object is repaired, lift the object with the crane and
put it in the center of the bracket, and fasten the object with the
steel chain.Ship lifter driven fluid pressure in appropriate places under the
car
5, close the unloading valve, step on the oil pump, lift the object
to the appropriate position, install the object, such as the object
position is not right, you can move the hydraulic lift or through
the adjusting hand wheel under the bracket to adjust.
| the highest height | 950mm |
| the minimum height | 145mm |
| the rated load | <=2ton |
| the weight | 105kgs |
Our products mainly include electric oil, gear oil pump series,
spanner, tow rope, high pressure gas cylinder, high and low
position conveyor, pneumatic oil injector injector.
Do we accept customization?
Yes, we can accept customization.
Can you help us to do some change about your product?
Yes, special drawing and design will be evaluated by our technical
department, unit cost will be calculated by finance department for
your final confirmation. All procedures will be informed and
confirmed with you in advance.
Can I get a sample?
Yes. Samples are welcome to us before mass production. But few
extra cost and products cost will be charge from customer first,
and sample cost will be back to customer once started mass
production.You need to pay the express fee.
Are you a factory or trading company?
xianxian zhongtuo hardware tools co.,LTD is specialized in the
production and development of automobile repair tools,equipment and
sales as one of professional manufacturers.
